Hi,

   Probably a dumb question, but I cannot figure out how to show arrow heads on pipes and planks.  I found this info

Show arrow on helix and Show arrow on strand (both default true) place arrowheads on the C-terminal ends of secondary structure elements to indicate N→C directionality.

These are not on the pipes and planks tool.
What is the format on the command line to use this commands

I tried
Show arrow on helix
Show arrow on helix true

Thanks

Evan
-------------------------------------------------------------------
Evan R. Kantrowitz, Ph.D                                                                  evan.kantrowitz@bc.edu
Boston College                                                                                   Tel. 617-552-4558
Department of Chemistry                                                                  FAX 617-552-2705                                     
Merkert Chemistry Center, Rm 239                                                  www2.bc.edu/~kantrow
Chestnut Hill, MA 02467
-------------------------------------------------------------------