hi! I am striving to perform voluertric filling of a crystal structure into an EM reconstruction. I have down loaded and complited the Linux_64 bit version. I first load my crystal structure and then the EM reconstruction on the same screen and set the EM reconstruction as DATa. I am not able to figure out where the FIT buttons is located in the pop up menus!!! I would be very grateful if you could help me sort out this issue! Thanks Jayant NB I am using the online manual to help me in this endeavour http://www.cgl.ucsf.edu/chimera/docs/ContributedSoftware/fitmodels/fitmodels... Jayasundar Jayant James Postdoc, Department of Veterinary and Comparative Anatomy, Pharmacology and Physiology(VCAPP), Washington state university, Pullman 99164-6520, USA. http://www.chick.com/reading/tracts/0001/0001_01.asp Phone office:335-5937, Cell:1-509-432-5790