Dear Chimera Team and Users, I like to clip the surface of a model (but not the model itself) using the command mclip. Unfortunately, this command apparently is waiting for a model number and therefore works on the surface as well as the model itself. On the other hand, the interactive tool "Per Model Clipping" allows to clip the surface only. Because I like to use clipping in a movie, using the interactive interface is not an option. Does anybody know how this could be acomplished using the command line? Kind regards, Richard Dr. Richard Marhoefer Senior Scientist BioChemInformatics Intervet Innovation GmbH Zur Propstei 55270 Schwabenheim, Germany E-Mail: richard.marhoefer@sp.intervet.com Phone: +49 (6130) 948 204 Fax: +49 (6130) 948 517 Mobile: +49 175 723 081 4 Home http://www.intervet.com Sitz der Gesellschaft: Schwabenheim Amtsgericht Mainz, HRB 23 166 Geschäftsführer: Dr. Peter Schmid -------------------------------------- This message and any attachments are solely for the intended recipient. If you are not the intended recipient, disclosure, copying, use or distribution of the information included in this message is prohibited -- please immediately and permanently delete. --------------------------------------