Dear Chimera team, I just stumbled on a bug that wasn’t present before (not sure from which version on).
Chimera gets stuck if you try to make a movie were a specific set of frames of a morph is recalled and at the same time the camera position is reset to save position.
Here the specific example that doesn’t work anymore, but did initially:
coordset #3 1,61,1
reset morph2 90
wait 90
Now I had to change, so that both movements happen independent.
coordset #3 1,61,1
wait 61
reset morph2 90
wait 90
Any change this bug could be fixed? It is a nice feature to be able to keep the morph going while it moves to another saved-position.
Best,
Cristina
____________________________________________________________________________________
Dr. Cristina Paulino
Assistant Professor at the Department of Structural Biology
Groningen Biomolecular Sciences and Biotechnology Institute (GBB)
Faculty of Science and Engineering , University of Groningen
Nijenborgh 7, 9747 AG Groningen, The Netherlands
Room 5171-0054
Phone: +31 50 363 34 02
____________________________________________________________________________________