Hi Chimera Team, I am sure this is a super dumb question but I have searched the documentation quite extensively and can;t seem to find a solution. I am trying to make a movie where I move through a tomogram in planes using the command: volume #1 planes z,200,0,1,1 wait But the wait does not seem to work - it just skips right to the next command and gets all snarled up. I can explicitly put in the number of frames but then the timing of the movie is all messed up. Any suggestions much appreciated. I also would rather be showing all 3 planes at the same time while I movie through the slab this but I can;t seem to find the right command to do that in a script. Thanks for any help you can provide, Best regards, Bridget ---------------------------------------------------------------------------------------------------------------------------------- Bridget Carragher, Associate Professor Automated Molecular Imaging Group, Department of Cell Biology The Scripps Research Institute, MC CB129,10550 North Torrey Pines Road, La Jolla, CA 92037 tel: (858) 784-9070; fax: (858) 784-9090; bcarr@scripps.edu; http://ami.scripps.edu National Resource for Automated Molecular Microscopy: http://nramm.scripps.edu ----------------------------------------------------------------------------------------------------------------------------------