Hello Chimera users and developers, I’m back again. So my movie rendering is progressing though I have of course run into more problems. I have one PDB file open, I need to create a surface around one molecule that is close to other molecules so running the surface command directly does not work as intended. I therefore have to split the PDB file and calculate a surface around a single molecule. All is well, however after this I run into some problems trying to clean up the script. I assume that I am defining the modelID incorrectly though I cannot figure out how. The following works: split #0 atoms :17.het surface probeRadius 0.5 vertexDensity 20.0 :17.het coulombic -5 red 0 white 5 blue :17.het wait combine #0.1-2 modelId 0 close true surftransparency 100 #0.1 This splits the model putting one residue (17) in a separate model, I calculate the surface without issue, color it by coulombic charges. I then have to combine the models (the single residue (17) and the rest of the residues) and close the old “residue 17” model. I then need to hide the newly created surface to display it at a later point in the movie. The script above works, however this does not seem very neat. I have experimented with different other commands, including transparency transp 100,s #0.1 Which also works well, as long as I split and combined the models. However, I have to combine the model for this to work! split #0 atoms :17.het surface probeRadius 0.5 vertexDensity 20.0 :17.het coulombic -5 red 0 white 5 blue :17.het wait combine #0.1-2 modelId 0 close true surftransparency 100 #0.1 Everything but hiding the surface works. transp 100,s #0.1 This does not work either in this case. I am assuming that I am not defining the model ID correctly for the surface and this is why I cannot hide it? I also tried using surfcat: surfcat templ :17.het surf probeRadius 0.5 vertexDensity 20.0 templ coulombic -5 red 0 white 5 blue templ wait surftransparency 100 templ or any of the following: surftransparency 100 #0 surftransparency 100 :17.het surftransparency 100 #0:17.het transp 100,s #0 Hides the created surface, what am I doing wrong in defining the surface to hide it and show it again? Thank you for any input and best regards // Gustaf