IMOD model reader question

I have an IMOD model (just a bunch of contours, representing filaments) that I tried to load into Chimera, but it threw some errors. This was odd, because it was a model I had augmented (added more contours) from a previous model that did load correctly (and I re-verified after the load error). is it helpful to forward the model file in question? best, -Jeff

Hi Jeff, The file is almost always needed to figure out a file-specific problem. However, why don't you send it to just me and Tom Goddard (goddard@cgl.ucsf.edu ) because I imagine the file is big and would require moderator approval to be sent to chimera-users, and our moderator is out today. I am not sure if Tom is back in town either, so it may be a while before we can give you an answer. Best, Elaine ----- Elaine C. Meng, Ph.D. meng@cgl.ucsf.edu UCSF Computer Graphics Lab (Chimera team) and Babbitt Lab Department of Pharmaceutical Chemistry University of California, San Francisco http://www.cgl.ucsf.edu/home/meng/index.html On Aug 11, 2008, at 8:25 PM, William Jeffrey Triffo wrote:
I have an IMOD model (just a bunch of contours, representing filaments) that I tried to load into Chimera, but it threw some errors. This was odd, because it was a model I had augmented (added more contours) from a previous model that did load correctly (and I re-verified after the load error).
is it helpful to forward the model file in question?
best,
-Jeff
participants (2)
-
Elaine Meng
-
William Jeffrey Triffo