distance label decimal places
Hi, does someone know how I can control the number of decimal places shown in a distance label using the command line? thanks! mathy
On Mar 28, 2013, at 2:49 AM, matheus froeyen wrote:
Hi,
does someone know how I can control the number of decimal places shown in a distance label using the command line?
Hi Mathy, There isn't such a command, but once you set the precision using the dialog then Chimera remembers that setting. Is there a specific reason you need to use a command for this? If there was, I could add such a command. --Eric Eric Pettersen UCSF Computer Graphics Lab http://www.cgl.ucsf.edu
To be more explicit, number of decimal places is a setting in the Distances panel (in menu under under Tools... Structure Analysis). Elaine On Mar 28, 2013, at 11:13 AM, Eric Pettersen wrote:
On Mar 28, 2013, at 2:49 AM, matheus froeyen wrote:
Hi, does someone know how I can control the number of decimal places shown in a distance label using the command line?
Hi Mathy, There isn't such a command, but once you set the precision using the dialog then Chimera remembers that setting. Is there a specific reason you need to use a command for this? If there was, I could add such a command.
--Eric
I try to generate the graphics by commands, avoiding the use of the menu interface, which works fine in most cases. If chimera will remember the setting, that is a good solution. best regards mathy On Thu, Mar 28, 2013 at 7:36 PM, Elaine Meng <meng@cgl.ucsf.edu> wrote:
To be more explicit, number of decimal places is a setting in the Distances panel (in menu under under Tools... Structure Analysis).
Elaine
On Mar 28, 2013, at 11:13 AM, Eric Pettersen wrote:
On Mar 28, 2013, at 2:49 AM, matheus froeyen wrote:
Hi, does someone know how I can control the number of decimal places shown in a distance label using the command line?
Hi Mathy, There isn't such a command, but once you set the precision using the dialog then Chimera remembers that setting. Is there a specific reason you need to use a command for this? If there was, I could add such a command.
--Eric
participants (3)
-
Elaine Meng -
Eric Pettersen -
matheus froeyen