Re: [Chimera-users] per-model clipping plane
Hi Jean-Francois,
There is not yet a command specifically to move per-model clip planes. But you can do it using the "savepos" and "reset" commands. These save and restore the positions of all models and the per-model clip plane positions (Chimera 1.2352 and newer).
For example, you can save an initial position with command
savepos p1
then move a per-model clip plane with the mouse to a new position and save that
savepos p2
then to smoothly go from position p1 to p2 over 100 frames use
reset p1 reset p2 100
The named positions are saved in Chimera session files.
Saving of per-model clip positions when you use savepos was added very recently (March 1, 2007) so you need Chimera snapshot version 1.2352 or newer. Formerly just the model orientations were remembered.
Tom
jean-francois menetret wrote:
Hi Thomas,
is it possible to move the per-model clipping plane using a movie-related command ?
Jean-Francois
participants (1)
-
Thomas Goddard