Dear specialists, I open a map(#1) and make icosahedron surface(#1) using Tools-> Higher-Order structure->icosahedron surface. But the model #0 and #1 don't have the same center, how could I center them into the origin of same coordinate? Thanks! -- Best regards! Jianhao
Hi Jianhao, Probably what you want is to change the map center, as described in this previous post: <http://plato.cgl.ucsf.edu/pipermail/chimera-users/2017-March/013209.html> I hope this helps, Elaine ---------- Elaine C. Meng, Ph.D. UCSF Chimera(X) team Department of Pharmaceutical Chemistry University of California, San Francisco
On Aug 17, 2017, at 12:56 AM, C.J. <biocjh@gmail.com> wrote:
Dear specialists, I open a map(#1) and make icosahedron surface(#1) using Tools-> Higher-Order structure->icosahedron surface. But the model #0 and #1 don't have the same center, how could I center them into the origin of same coordinate? Thanks! -- Best regards! Jianhao
Hi Elaine, This really helps, and Thanks! Regards, Jianhao 2017-08-18 0:55 GMT+08:00 Elaine Meng <meng@cgl.ucsf.edu>:
Hi Jianhao, Probably what you want is to change the map center, as described in this previous post:
<http://plato.cgl.ucsf.edu/pipermail/chimera-users/2017-March/013209.html>
I hope this helps, Elaine ---------- Elaine C. Meng, Ph.D. UCSF Chimera(X) team Department of Pharmaceutical Chemistry University of California, San Francisco
On Aug 17, 2017, at 12:56 AM, C.J. <biocjh@gmail.com> wrote:
Dear specialists, I open a map(#1) and make icosahedron surface(#1) using Tools-> Higher-Order structure->icosahedron surface. But the model #0 and #1 don't have the same center, how could I center them into the origin of same coordinate? Thanks! -- Best regards! Jianhao
-- Best regards! C.J.
participants (2)
-
C.J. -
Elaine Meng