icosehedron enhancement

for the mesh adjustment, it would be good to be able to enter the radius of the mesh tubes. currently I have to select the item, go to the inspector to set the radius. Matthew Dougherty National Center for Macromolecular Imaging Baylor College of Medicine

Hi Matt, Sounds like a good idea. I was thinking it might be possible to do with a "setattr" or "sop" command, but unfortunately couldn't find such a solution. You can see from the mouseover help on the attribute inspector that it is a surface-piece attribute named lineThickness. If it were an attribute of the whole surface model instead, it would be possible to change it with "setattr M" (e.g. for the display attribute: setattr M display false). Tom is on vacation currently, but he may get back to you upon his return. Best, Elaine ----- Elaine C. Meng, Ph.D. UCSF Computer Graphics Lab (Chimera team) and Babbitt Lab Department of Pharmaceutical Chemistry University of California, San Francisco On Jun 28, 2013, at 9:41 PM, Dougherty, Matthew T wrote:
for the mesh adjustment, it would be good to be able to enter the radius of the mesh tubes. currently I have to select the item, go to the inspector to set the radius.
Matthew Dougherty National Center for Macromolecular Imaging Baylor College of Medicine

Ok, I added mesh line width to the icosahedron surface dialog. It is measured in screen pixels. Will be in tonight's daily builds. Tom On Jun 28, 2013, at 9:41 PM, "Dougherty, Matthew T" wrote:
for the mesh adjustment, it would be good to be able to enter the radius of the mesh tubes. currently I have to select the item, go to the inspector to set the radius.
Matthew Dougherty National Center for Macromolecular Imaging Baylor College of Medicine
participants (3)
-
Dougherty, Matthew T
-
Elaine Meng
-
Tom Goddard