Dear ChimeraX Maintenance Team, I hope this email finds you well. I am writing to seek assistance regarding an issue I have encountered while working with protein models in ChimeraX. After performing MPL calculations on protein models, I have found that I am unable to modify the dot size of the resulting surface representation. In Chimera, this task was easily accomplished through the "Model Panel" by adjusting the "MSMS Model Attributes". However, I have not been able to find a similar option or command in ChimeraX. I would greatly appreciate it if you could provide guidance or suggest a solution to address this matter. Being able to adjust the dot size of the surface representation is crucial for my current research project, and I rely heavily on the functionalities provided by ChimeraX. Thank you very much for your attention to this matter. I look forward to your kind assistance and prompt response. Best regards, Zhuangwei Zhang, Ph.D. State Key Laboratory of Analytical Chemistry for Life Science, Collaborative Innovation Centre of Chemistry for Life Sciences School of Chemistry and Chemical Engineering Nanjing University E-mail: dg21240166@smail.nju.edu.cn