Dear Chimera team, I just stumbled on a bug that wasn’t present before (not sure from which version on). Chimera gets stuck if you try to make a movie were a specific set of frames of a morph is recalled and at the same time the camera position is reset to save position. Here the specific example that doesn’t work anymore, but did initially: coordset #3 1,61,1 reset morph2 90 wait 90 Now I had to change, so that both movements happen independent. coordset #3 1,61,1 wait 61 reset morph2 90 wait 90 Any change this bug could be fixed? It is a nice feature to be able to keep the morph going while it moves to another saved-position. Best, Cristina ____________________________________________________________________________________ Dr. Cristina Paulino Assistant Professor at the Department of Structural Biology Groningen Biomolecular Sciences and Biotechnology Institute (GBB) Faculty of Science and Engineering , University of Groningen Nijenborgh 7, 9747 AG Groningen, The Netherlands Room 5171-0054 Phone: +31 50 363 34 02 Email: c.paulino@rug.n <mailto:c.paulino@rug.nl>l https://www.rug.nl/research/electron-microscopy <https://www.rug.nl/research/electron-microscopy> http://www.membraneenzymology.com <http://www.membraneenzymology.com/> ____________________________________________________________________________________