As I understood it, if you wanted to change the orientations, the way to do it is to undo a previous tile so that everything is superimposed again, then change orientation, then use tile again. I don't think repeatedly using "tile" from a previously tiled state was intended. Elaine
On Sep 30, 2021, at 5:46 PM, Tom Goddard via ChimeraX-users <chimerax-users@cgl.ucsf.edu> wrote:
Hi Pranav,
I have seen similar bad layout from the tile command. If I open 3 copies of a model the tile them it works, then rotate just one and try to tile several times and it gives all kinds of weird wrong positions.
open 1a0m ; open 1a0m ; open 1a0m tile turn y 140 model #1 tile tile
I've made a bug report for this and hope to fix it soon.
https://www.rbvi.ucsf.edu/trac/ChimeraX/ticket/5320
Tom
On Sep 30, 2021, at 5:21 AM, Pranav Shah via ChimeraX-users <chimerax-users@cgl.ucsf.edu> wrote:
Hi, I want to create an image of multiple volumes that are tiled horizontally. However, when I run the command "tile columns 6" the volumes get arranged in a step-like manner (attached image). I do not see this happen in chimera so I am wondering if this expected behaviour in ChimeraX? I am on UCSF ChimeraX version: 1.2.5 (2021-05-24) on the M1 MacBookPro, MacOS 11.6.
Best, Pranav -- Pranav Shah Postdoctoral Research Fellow.
Division of Structural Biology, Wellcome Trust Centre for Human Genetics, University of Oxford, Roosevelt Drive, Oxford OX3 7BN, UK <image.png>_______________________________________________ ChimeraX-users mailing list ChimeraX-users@cgl.ucsf.edu Manage subscription: https://www.rbvi.ucsf.edu/mailman/listinfo/chimerax-users
_______________________________________________ ChimeraX-users mailing list ChimeraX-users@cgl.ucsf.edu Manage subscription: https://www.rbvi.ucsf.edu/mailman/listinfo/chimerax-users